Your cart
There are no more items in your cart
Adhesive for installing PVC design flooring, linoleum, rubber flooring up to 2.5 mm thick, needle-punched textile flooring, synthetic or jute mesh, woven and needle-punched carpets on absorbent substrates, as well as PVC and CV flooring on absorbent and non-absorbent substrates. WAKOL D 3360 complies with DIN EN ISO 22636.
Application
Universal dispersion adhesive for installing:
- PVC design flooring
- needle-punched textile flooring, synthetic, jute, and latex double backing
- woven flooring
- needle-punched flooring
- linoleum flooring
- rubber flooring up to 2.5 mm thick on properly prepared absorbent screeds indoors.
- Homogeneous and heterogeneous PVC floor coverings in rolls and tiles
- Cushioned vinyl floor coverings on properly prepared absorbent and non-absorbent screeds indoors.
Special Features
- Solvent-free as defined by TRGS 610
- Can be used in multiple applications
Technical Data
- Base raw material: Acrylate dispersion
- Evaporation time: approx. 10-20 minutes depending on the toothing of the spatula, the screed, and the floor
- Open time: approx. 20-30 minutes
- Cleaning agent: Water, before the adhesive begins to dry
- Storage time: 12 months at room temperature
- Storage temperature: not below +5°C, sensitive to freezing
Application and consumption*
TKB A1 approx. 250-280 g/m² chemically etched floor coverings
TKB A2 approx. 300 - 350 g/m² PVC design flooring, homogeneous and heterogeneous PVC flooring in rolls and tiles, chemically etched flooring, rubber flooring
TKB B1 approx. 400 - 450 g/m² textile flooring, woven flooring, linoleum flooring
TKB B2 approx. 500 - 550 g/m² textile flooring and woven flooring with a rough substrate structure, needle punched flooring
*)Consumption depends on the surface structure and the absorption capacity of the screed.
Screeds
On cast asphalt screeds, use only Wakol reactive resin primers such as WAKOL PU 280 Polyurethane Primer. Screeds must be permanently dry, firm, smooth, and free of cracks, dirt, and substances that impair adhesion.
Fill large uneven screeds with appropriate Wakol leveling compounds. Follow the technical information for primers and smoothing compounds.
Install PVC and chemically etched flooring over non-absorbent screeds using the bonding method. Joints that are in the bonding phase may allow for improved residual print performance.
Application
Stir the adhesive well before use. Apply evenly to the screed using a notched trowel, avoiding adhesive buildup. Lay the flooring, allowing the required ventilation time for a perfect fit, and smooth thoroughly. Smooth again after a few minutes.
Generally, rubber flooring should be installed using the wet bonding phase. Smooth again with a roller after approximately 1 hour.
If necessary, apply weight to the edges of the flooring until the adhesive sets.
On non-absorbent screeds, wait until the bonding phase begins before installing the flooring. Rub again after a few minutes. Stir the adhesive well before using. Apply evenly to the floor using a notched trowel, avoiding adhesive buildup.
