Colour-intensifying, water-based polyurethane sealer prior to the application of panDOMO® SP-PS. Solvent-free. Low odour. Exceptional performance. EC1 Plus. Water vapour permeable.
PANDOMO SP-CEE is a 2-component colour intensifying emulsion based on polyurethane and water. Not suitable as a sealer. Must be applied before PANDOMO SP-PS sealer on suitable floors.
Uses: Interior. Flooring.
To intensify the colour of PANDOMO K1, K2 and K3.
Application over PANDOMO K1, PANDOMO K2 and PANDOMO K3:
After applying PANDOMO Floor, FloorPlus or Loft and allowing the surface to dry for the appropriate time (approx. 12 hours), it must be polished with a suitable sander (e.g. TRIO from Lägler) according to the manufacturer's instructions.
PANDOMO K1 and K3 should be polished with 120 grit paper; for PANDOMO FloorPlus and K2 use 100 grit paper.
Mix the two components of PANDOMO SP-CEE together using a spiral mixing paddle. Continue mixing for at least 2 minutes. To avoid ineffective mixing, after the initial mixing, transfer the material to a new clean container and shake again.
Using a flexible blade or squeegee, apply a thin layer of the material to the dust-free surface of PANDOMO Floor, Floor Plus and Loft, and rub immediately with a single disc rotary polishing/cleaning machine with gentle rotary polishing/cleaning.
Excess material and clumps can leave marks and should be worked thoroughly until no residue remains.
On dark coloured surfaces, it is recommended to apply a second coat of PANDOMO SP-CEE as described above. This is to avoid colour differences.
Notes:
After application, no splashes, polishing machine residues or sheen should be visible on the surface.At the end of the process, the surface should have a satin finish. Drying time: minimum 12 hours.
Ensure good ventilation and working conditions during drying and setting of PANDOMO SP-CEE and prevent dust and other impurities from adhering to the surface. Do not apply at temperatures below +15°C. Non-toxic to humans and animals after setting.
Use appropriate protective equipment (gloves, goggles) when applying the product. Not suitable for permanently wet areas.
Colour fastness:
Prolonged exposure to UV rays may cause slight yellowing of PANDOMO SP-CEE.
Cleaning and disposal:
Clean all mixing utensils and containers thoroughly with clean, fresh water after use.
Refer to the safety data sheet for disposal of leftover material (mixed or unmixed).
Warning:
Component A: None
Component B: May cause allergic skin reactions.hazardous to health if inhaled. May cause respiratory irritation. Keep out of reach of children. Use only in well-ventilated areas. Wear protective gloves. Wear eye protection. Avoid inhalation of vapours/aerosols.
IF ON SKIN: Wash with plenty of soap and water.
IF INHALED: Remove affected persons to fresh air and keep at rest in a position where they can breathe freely and comfortably.
Contains isocyanates. May cause allergic reactions.
Dispose of contents/containers in accordance with local/regional/national/international regulations.
PANDOMO SP-CEE is harmless after setting.