WAKOL DL3365 StarLeit - Acrylic Resin Adhesive

Light-colored, water-dispersed acrylic resin adhesive with fibers for installing conductive textile, PVC, linoleum, and rubber flooring up to 4 mm thick on specially prepared substrates. WAKOL DL 3365 complies with DIN EN ISO 22636.

Application:

• - PVC floor coverings in rolls and tiles
• - textile floor coverings
• - linoleum floor coverings
• - rubber floor coverings up to 4 mm thick on properly prepared absorbent screeds indoors.

Special Features

1. - Solvent-free according to the definition of TRGS 610
2. - Conductive
3. - Can also be used for textile flooring without a conductive primer
4. - Suitable for underfloor heating
5. - Suitable for chair casters
6. - EMICODE EC1 PLUS category: very low emissions, according to GEV criteria
7. - A+ emission category according to French law
8. - GISCODE D1 dispersion installation materials, solvent-free
9. - Construction product tested for emissions according to DIBt principles: Wakol GmbH, 66954 Pirmasens
10. - Polish B mark for construction products in accordance with EN 14259
11. - Suitable for installation over underfloor heating
12. - Meets European Community specifications
13. - Product for installation with conductive capacity for flooring

Technical Data

• Base raw material: Acrylate dispersion
• Material composition: polyacrylate-polystyrene dispersions, water, conductive fibers, wetting agents, Thickeners, defoamers, and preservatives, mineral fillers, natural resin
• Evaporation time: approximately 10–15 minutes depending on the trowel's notch, the screed, and the floor
• Open time: approximately 15 minutes. 20-40 minutes
• Cleaning agent: Water, before the adhesive begins to dry
• Shift resistance according to UNE-EN ISO 22637: < 3 x 10⁵ Ohm
• Storage temperature: not below +5°C, sensitive to freezing
• Storage time: 12 months at room temperature

Application and consumption*

• Pajarito 7 300-350 g/m² rubber flooring PVC flooring
• TKB S2 400-450 g/m² linoleum textile flooring (in combination with WAKOL DL 3078 Conductive Primer)
• Pajarito 25 500-550 g/m² textile flooring

* Consumption depends on the surface structure and the absorption capacity of the screed.

Screeds

Both the subfloor and the interior climatic conditions must meet the requirements of the current standards and technical data sheets. Screeds must be permanently dry, firm, smooth, and free of cracks, dirt, and substances that impede adhesion.

Fill non-absorbent and uneven screeds with the appropriate Wakol smoothing compounds. The technical information for the primers and smoothing compounds must be observed.

Application

Suitable conductive textile flooring does not require a conductive primer. In all other cases and if there are special requirements, WAKOL DL 3078 conductive primer must be applied to the ready-to-install screed using a WAKOL Primer Roller, 11 mm. A tight film must form. Before gluing the top screed, allow the primer to dry completely: at least 3-5 hours with good ventilation. Installation can also be carried out over a copper tape mesh.

Attention! Observe any additional guidelines specified by the flooring manufacturer.

Stir the adhesive thoroughly before use. Apply evenly to the subfloor using a notched trowel, avoiding adhesive buildup. Lay the flooring, allowing the flashing time to pass, and rub thoroughly. Rub again after a few minutes. If necessary, apply weight to the edges of the flooring until the adhesive sets.