WAKOL D965 - Carpet Fixing Adhesive

Dispersion adhesive for the non-slip installation of textile tiles with bitumen, felt, PVC, or PUR backings on absorbent and non-absorbent substrates.

Application

Anti-slip dispersion adhesive for the installation of:

• - self-adhesive carpet tiles with asphalt or needle-punched backing
• - self-adhesive carpet tiles with PVC or PUR backing on properly prepared absorbent and non-absorbent screeds indoors.

Special Features

1. - Solvent-free according to TRGS 610 definition
2. - EMICODE EC1 PLUS: Very low emissions according to GEV criteria
3. - A+ emissions category according to French law
4. - GISCODE D1, Dispersion-based installation materials, solvent-free
5. - Construction product tested for emissions according to DIBt principles: Wakol GmbH, 66954 Pirmasens
6. - Suitable for installation over underfloor heating
7. - Meets European Community specifications

Technical Data

• Base raw material: Dispersion mix
• Evaporation time: approx. 30-60 minutes
• Open time: approx. 24 hours after drying
• Cleaning agent: Water, before the adhesive begins to dry
• Storage time: 12 months at room temperature
• Storage temperature: not below +5°C, sensitive to freezing

Application and consumption*

WAKOL Primer Roller, 11 mm foam roller: 80-100 g/m² on non-absorbent screeds

WAKOL Primer Roller, 11 mm short-pile roller: 120-150 g/m² on absorbent screeds

* Consumption depends on the surface structure and absorption capacity of the screed.

Screeds

Both the subfloor and the indoor climatic conditions must meet the requirements of current standards and technical data sheets. Screeds must be permanently dry, firm, smooth, and free of cracks, dirt, and substances that impair adhesion.

Smooth surfaces are required for fixing SL carpet tiles; Therefore, screeds with a rough surface must be primed and puttied. The technical information for primers and smoothing compounds must be followed.

Access floors must be firmly bonded to the screed and their surface must be free of wax or care products.

Application

Remove the dispersion binder before use. Apply evenly to the screed using a WAKOL primer roller, foam roller, or short-pile roller, avoiding buildup of dispersion binder. When installing on double floor elements, ensure that WAKOL D 965 Dispersion Binding Agent does not penetrate between the panels. If necessary, protect the butt joints with adhesive tape. Once the binder layer has dried (transparently), lay the carpet tiles and rub in thoroughly. Rub again after a few minutes. For conductive installations, mix WAKOL D 965 Dispersion Fixer with WAKOL DL 352 Conductive Dispersion Fixer in a 4:1 ratio.